How to tie a tie

Windsor Knot:

Half Windsor Tie Knot Instructions

1. Flip up your shirt collar and lay your tie around your neck so that the inseam faces the inside. Make sure to let the broad end of the tie hang a few inches lower than the narrow end.
2. Take the broad end and wrap it from behind through the loop on your neck area.
3. Slightly pull tight, and then take the broad end behind the narrow end of the tie.
4. Loop it over the narrow end and back though the loop – just as you did in Step #2. Don’t pull tight yet.
5. Take the wide end and pull it rhough the loop you created in the previous step.
6. Carefully tighten the knot, give it some final adjustment, center it, and flip down the shirt collar. You are done with the half Windsor necktie knot.

Kent Knot:

Instructions: Tying a perfect Kent tie-knot

1. 1.Begin as with the “Four in hand” necktie knot and put the tie around the neck, with the broader and longer part on the left. Then twist the broad end of the tie for about 180 degrees so that the seam is showing to the front. This is necessary to give the next loop more support.

2. 1.First cross the broad end underneath the narrow end and then go back crossing over.

3. 1.Then form a loop with the broad end going through from the back to the front.

4. 1.Pull the broad end of the necktie through the loop and we are done! – A perfect “Kent tie knot”.